Lambretta Furgone C 125
The Lambretta Furgone C 125.
Technical Specification
Model | Furgone C 125 |
Production Started | November 1950 |
Production Ended | October 1952 |
Frame Prefix | N/A |
Engine Prefix | 125 M |
Starting Frame N° | 10001 |
Starting Engine N° | 10001 |
Amount Produced | 3,001 |
Engine | 123cc, two stroke, 52x58mm |
Power & Rate | 4 HP at 4,400RPM |
Compression Ratio | 1:6 |
Head & Cylinder | Aluminium & Cast Iron |
Engine Cooling | Forced Air |
Crankcase Oil | Mobil Oil A 180grams |
Starter | Pedal |
Clutch | Multiple discs in oil bath |
Gears | 3 speed hand shifter (teleflex) |
Gear Ratios | 1st 1:19 |
2nd 1:11 | |
3rd 1:7 | |
Ignition | Filso or Marelli |
Spark Advance | 26°-28° 33-35mm on the circumfrance of the flywheel |
Point Settings | .40-.50mm |
Sparkplug | Bosch 225, short thread |
Primary | Gear |
Secondary | Shaft and gear |
Transmission Oil | Special Mobil grease 430grams |
Carburetor | dell'orto MA16 or Zenith 18MTC |
Carburation | MA16 Main 68, Pilot45, valve 55. 18MTC Main 80-84, Pilot 40 |
Fuel Mix | 5.00% |
Fuel Consumption | 1lt per 30-35km |
Fuel Capacity | 6.3lt plus .7lt reserve |
Range | |
Maximum Speed | 50.7km/h |
Brake Type | Front:Mechanically controlled drum |
Rear: Mechanically controlled drum | |
Tire | 4.00 x 8 |
Tire Pressure | Front: 1.6ATM |
Rear: 1.6ATM | |
Front | Oscillating arms with crosswise leaf springs |
Rear | Joint attached to motor with hydraulic shock absorber |
Dry Weight | 140kg |
Longitudinal Dimension | 2,480mm |
Transversal Dimension | 1,200mm |
Vertical Dimension Box | 1,060mm |
Max Hight | 1,060mm |
Ground Clearance | 150mm |
Wheel Base | 1,557mm |
Track Width | 1,050mm |
Minimum Turning Radius | 3,500mm |
Load Capacity | 220kg |
System | 6 Volt with 7amp battery |
Frame | Steel tubing with 1,557mm resistence |
Cab | N/A |
Trunk Type | Aluminum compartment |
Wooden compartment | |
Wooden compartment with wood reinforcing on the edges | |
Wooden pickup trunk with wood reinforcing on the edges | |
Also available as chassis only | |
Colours | Grey, Green, Blue |
Steering | Handlebar |
Accelerator | Actuated by twisting of the right handlebar grip |
Brakes | Foot pedal operates both front and rear combined |
with a seperate lever on the right handlebar controling the rear independantly | |
Clutch | Left lever on right handlebar |
Gears | Actuated by twisting of the left handlebar grip with clutch engaged |
Copyright © 2018-2025 - All Rights Reserved - British lambretta Archive
Design by John Walklate